⚠️
About This Content
These tips are automatically generated by an AI language model via Ollama. While the content aims to be helpful, it may contain errors or outdated information. Always verify advice against reliable sources before applying it to your projects.
All images are original photographs taken by the project creator from actual scale models. However, the card images may not necessarily illustrate the specific tip on that card — they are selected randomly from the available photo collection for visual variety.
1
Fixing Silvered Decals After They Have Dried
Silvered decals happen when air is trapped under the decal. To fix after drying: apply Mr. Mark Softer generously over the decal, wait 10 minutes, then press gently with a damp cotton swab from the center outward to force air bubbles out. Repeat twice more with fresh solution. If silvering persists, carefully slit the decal film with a fresh hobby knife blade in a crosshatch pattern, apply setting solution again, and press flat. Once fully settled, seal with a gloss coat. For stubborn cases, replace the decal and reapply with stronger solutions like Daco Strong.
🔍 Search for more
2
Removing Old Paint from Plastic Kits
To remove old paint from plastic kits without damaging the surface, use Citadel's Dettol Liquid Soap (not the gel). Dilute 1 part soap with 3 parts warm water, apply with a soft brush, let it soak for 10 minutes, then gently scrub with a soft toothbrush. Rinse with warm water and dry. For tougher cases, use Tamiya Extra Thin Cement to soften the paint, then gently scrape off with a scalpel.
🔍 Search for more
3
Fixing Broken Photo-Etch Parts
To fix broken photo-etch parts, use CA (Cyanoacrylate) glue like Mr. Hobby's Super Clear. Apply a tiny drop on the inside of the joint, let it soak for 30 seconds, then press the parts together firmly. Wipe off excess glue immediately with a damp cotton swab. Once dry, reinforce the join with a small amount of Vallejo Plastic Putty, let it dry, then sand and paint as normal.
🔍 Search for more
4
Recovering Clogged Airbrushes
To recover a clogged airbrush, first disassemble it and soak the nozzle and needle in Vallejo Airbrush Thinner for 10 minutes. While soaking, use a soft brush to scrub the airbrush cup with a mild detergent. Reassemble the airbrush, then using Iwata's airbrush cleaning kit, pump 50% Vallejo Airbrush Thinner, 25% water, and 25% detergent through the airbrush until it's flowing smoothly. Finally, test spray with water to ensure no further clogs.
🔍 Search for more
5
Repairing Warped Plastic Parts
To repair warped plastic parts, soak them in warm water for 10 minutes to soften. Gently bend the parts back into shape while submerged. Once shaped, lay them flat on a baking sheet lined with parchment paper, then place in a oven at 140°F (60°C) for 10-15 minutes to set the new shape. Allow to cool before handling. For severe warping, consider using a hot air gun to gradually heat and bend the part into shape.
🔍 Search for more
